truck-trans-dodge
truck-logo-dodge
Search Messages :  

Strobe or flash

From : partsmore

Q: as a responder / emt for our local department we are allowed to have strbe or speed flash on vechicles when responding to the station. i have an 05 ram daytona. does anyone know of an easy way to make flashers / hazards and or lights strobe on these pleasse send product location site or instructions. info@thevbattery.com http//www.chiefsupply.com/vehicle-flashers.phtml -- coasty remove the spooge to reply .

Replies:

From : christopher thompson

i had a brand new 02 2wd dakota club cab for work-and a work owned truck...used it to pick up a yard of loam for my house....mr. fleet manager-safety guy driving the trailer hitch home with 3000 lbs. of wet loam in the back of a dakota....talk about crying while you drive..but i really needed the loam youd be surprised how much steering you dont have when you put that much over....never again .

From : christopher thompson

where is it in the engine compartment where the fuel pressure sensor is you get at it from the top of the engine compartment drivers side close to the firewall. looking in from the drivers front fender to the right and down from the fuel filter. you will see the fuel lines. roy thanks charles roy wrote i picked up my truck today 2001 2500 td 24 valve after having egt and fuel pressure gauges installed. at idle fuel pressure is like 5-7 psi it hunts. while driving it is around 3 max going up a hill truck is not really trying it can drop to 1 or 2 psi. that is too low. what should the pressure be at idle when driving when working hard does this mean i need to replace the lift pump before it takes out the main fuel pump yes it will cause your inj pump to fail. about $2500 for that puppy. my friends say carquest sells the same pump as you get from cummins for a lot less. around $100 i think. main pump they say is a $2000 job. is it hard to do or get at if so i have a mechanic that can do it. it should take 1/2 hour the first time. very easy to do. roy .

From : steve w

where is it in the engine compartment where the fuel pressure sensor is you get at it from the top of the engine compartment thanks charles roy wrote i picked up my truck today 2001 2500 td 24 valve after having egt and fuel pressure gauges installed. at idle fuel pressure is like 5-7 psi it hunts. while driving it is around 3 max going up a hill truck is not really trying it can drop to 1 or 2 psi. that is too low. what should the pressure be at idle when driving when working hard does this mean i need to replace the lift pump before it takes out the main fuel pump yes it will cause your inj pump to fail. about $2500 for that puppy. my friends say carquest sells the same pump as you get from cummins for a lot less. around $100 i think. main pump they say is a $2000 job. is it hard to do or get at if so i have a mechanic that can do it. it should take 1/2 hour the first time. very easy to do. roy .

From : partsmore

on sun 20 nov 2005 011631 gmt christopher thompson kf4drr@earthlink.net wrote even worse than it already was since he was not driving carelessly. like i said before there are just too many variables. ok i gotta ask.... so driving essentially blind folded is not careless not if the conditions that are causing it are beyond your control. ok... what part of the country are you in so i know not to go there. now i dont care who you are that was funny. -- if at first you dont succeed youre not cut out for skydiving .

From : hp

you may have better luck with this question at rec.autos.sport.nascar john .

From : coasty

on thu 17 nov 2005 232457 gmt denny wddodge@woh.rr.com wrote the mercury dropped last night and this morning was sheer bliss! with the touch of a button my tush was toasty warm in minutes.... life is good! mike a sack of white castle burgers warms my tushy up just fine....and usually in less than a minute.. denny im trying really hard not to visualize a bunny sitting on a bag of little burgers... argggg.. youve obviously have never eaten a white castle. the greasy thin little burger cooked in onion bits hiding inside a dinner roll sized bun. just add a piece of cheese and ingest 8-10 of these bite sized morsels and youre guaranteed to have gas thatll clear off the entire parts counter for at least five minutes.. ahhhh the friends that youll make......... denny i will occasionally send a porter for a couple of crave packs thats a case of 24 whiteys for the uninitiated for the guys in the shop. this of course is only permitted during the warm weather months when the shop doors can remain open. to do so in the winter would be suicide. yup they can clear the parts counter in a heart beat! mike i didnt realize you had wc out there in mo. the next time that you know the cust from hell is coming in ingest a few sliders and then go for a test drive with him. youll either win him over or hell go buy a honda.. youll win either way.. bg denny .