Removing transmission and clutch fingers
From : marsh monster
Q: .. .. inline =3d=3d=3d=3d=3d=3d=3d=3d=3d=3d =3d=3d=3d=3d=3d=3d=3d=3d=3d=3d concerning release bearing to pressure plate clearance mr-d150@spam.citlink.net budd=a0cochran worte in message snip by design there is supposed to be a small fraction of a inch clearance. this was seen in the mechanical systems as your pedals freeplay. when air is left in the system the air can warm up and expand causing the fingers to ride the bearing. -- budd cochran =3d=3d=3d=3d=3d=3d=3d=3d=3d=3d=3d=3d =3d=3d=3d=3d=3d=3d=3d=3d=3d=3d=3d=3d by design there is supposed to be no small faction of a inch clearance. though... this was seen in the mechanical systems as your pedals freeplay. when air is left in the system......... there is no way in hell it will ever warm up and expand causing the fingers to ride the bearing......especially being as the bearing is already riding on fingers. a question........... if the air could....expand due to heat and apply the bearing..... then why isnt the fluid expanding and applying the bearing air compresss brake fluid does not marshmonster sips his axle grease .