OT: Look, Ma, no gas!

From : jmc

Q: crag hes up to the same tricks in rec.autos.makers.jeep+willys. thread re ot electronics electrical problem = snoman the lying stalker! gee ... with beryl being such a whiz with electronics i wonder why he isnt defending him lahoooo zaherrrrr. - craig c. im not an electrowiz graywacke. and i dont read that jeep group either. -- this explains it all!!! he was home schooled and his mommy made his ges diploma for him out of needle point to go with his pin head and needle dick. -- punkin .

Replies:

From : beekeep

on thu 31 may 2007 180718 -0400 roy roy@home.net wrote hes like a friggin plague. the cc hes a poser no roy i am likely a nightmare for you because i see right through you tripe that you post at times and it bugs you to no end. ----------------- thesnoman.com .

From : craig christian

i like the ranch hand bullnose bumper with winch mount. anybody know the cheapest source available online thanks -- nathan in montana http//concealedcarryforum.com http//1911talk.com http//glockcarry.com http//hipowertalk.com .

From : nosey

i wonder if spraying something on the driveshaft may cause a balance problem. i dont think i would do that if it were mine. denny someone mechanically inclined might be able to figure out how balance a drive shaft with a couple of jack stands two hose clamps and a piece of chalk. not that im suggesting anyone should go under a running vehicle in gear on jack stands with a piece of chalk to mark the heavy side of the spinning shaft then put the hose clamps on the shaft with the worm gear on the opposite side of the chalk mark or anything dangerous like that. but it works. not that id do anything like that myself. nope not me. ;^ -- ken .

From : the reverend natural light

on fri 1 jun 2007 172524 -0400 denny wddodge@woh.rr.com wrote i wonder if spraying something on the driveshaft may cause a balance problem. i dont think i would do that if it were mine. not really. drive shafts are not balance that close from factory anyway and i have not seen a drive shaft yet from any brand truck that could not be rebalnace better at a drive shaft shop even when they were new. the deeprer you axle ratio is relatiive to tire size maakes balance a bit more important as it increase average rpm of drive shaft. it takes time to get them dead on and detriot does not have time for this on assembly line. spraying it will have a negligable impact on the balance of it. ----------------- thesnoman.com .