Bearing squeak
From : edtheward
Q: i have a 2000 4x4 short cab ram. i can hear the front driver side wheel squeak when i am close to a building driving very slow like fast food drive thru slow. is it easy to repack and/or replace the bearing or do i need any special tools. any advise would be helpful. thanks .
Replies:
From : tom lawrence
driving very slow like fast food drive thru slow. is it easy to repack and/or replace the bearing or do i need any special tools. theyre sealed bearings - you have to replace them. cost is between $200 and $300. youll need a large 3/4 drive - somewhere around 1-11/16 socket for the axle nut and a 12-point 14mm socket for the hub bolts. a hub puller is nice to have but not a necessity. when you go to get the bearing you can get this at a parts store like napa autozone etc. theyll need to know if you have 4-wheel abs or not. .
From : clare at snyder on ca
on sat 04 mar 2006 002452 gmt edtheward blarg@blarg.net wrote i have a 2000 4x4 short cab ram. i can hear the front driver side wheel squeak when i am close to a building driving very slow like fast food drive thru slow. is it easy to repack and/or replace the bearing or do i need any special tools. any advise would be helpful. thanks sounds like your brake pads may be getting low rolling element bearings rumble not squeek. *** free account sponsored by secureix.com *** *** encrypt your internet usage with a free vpn account from http//www.secureix.com *** .
From : carolina watercraft works
check here...lots of info http//www.quad4x4.com/ -- ------------------------------------------ laszlo almasi cool toys formerly carolina watercraft works ice angels i have a 2000 4x4 short cab ram. i can hear the front driver side wheel squeak when i am close to a building driving very slow like fast food drive thru slow. is it easy to repack and/or replace the bearing or do i need any special tools. any advise would be helpful. thanks .
From : bob
edtheward wrote i have a 2000 4x4 short cab ram. i can hear the front driver side wheel squeak when i am close to a building driving very slow like fast food drive thru slow. is it easy to repack and/or replace the bearing or do i need any special tools. any advise would be helpful. thanks i had the same irritating noise in an 84 t-bird. only the passenger side. only at slow speeds. only when next to a building or tall curb with the window open. car drove just fine no issues at all. i repacked and adjusted the bearings. more than once. checked the pads. checked everything i could think of. more than once. i was just about to decide to live with it. then i found a loose wheel weight on the inside of the wheel. tightened that up and the noise went away. -- ..bob on order 2006 fxdi red. 1997 hd fxdwg - turbocharged stolen 11/26/05 in denver 1hd1gel10vy3200010 co license j5822z 2001 dodge dakota qc 5.9/4x4/3.92 1966 mustang coupe - daily driver 1965 ffr cobra - 427w efi damn fast. .
From : cc
hi edward you might also check the wear tab or the front rotors. specially if you havent put brakes on the front yet. cc .